Siemens Sinumerik 840D sl Diagnostic Manual page 47

03/2009
4291 Failure of module in local P-bus slot %1, error codes %2 %3 %4
Parameters: %1 = Slot number
%2 = Error code
%3 = Error code
%4 = Error code
Definitions: The module on the specified slot has signaled a diagnostics alarm. The error code reported corre-
sponds to the AS300 documentation.
Reaction: NC not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Check hardware.
Program Con- Switch control OFF - ON.
tinuation:
4300 Declaration in MD %1 is not allowed for axis %2.
Parameters: %1 = String: MD identifier
%2 = Axis name, spindle number
Definitions: The axis cannot be operated as competing positioning axes,
for example because the axis is the slave axis within a closed gantry group or a gantry group to be
closed.
Reaction: Alarm display.
Remedy: Please inform the authorized personnel/service department. Reset MD30450
$MA_IS_CONCURRENT_POS_AX for the axis concerned.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
4310 Declaration in MD %1 index %2 is not allowed.
Parameters: %1 = String: MD identifier
%2 = Index: MD array index
Definitions: The machine data values must be written in the array in ascending order.
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Correct the MD.
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
4320 Axis %1 function %2 %3 and %4 not allowed
Parameters: %1 = String: Axis identifier
%2 = String: MD identifier
%3 = String: Bit
%4 = String: MD identifier
Definitions: The functions declared by the specified machine data cannot simultaneously be active for one axis.
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Deactivate one of the functions.
Program Con- Switch control OFF - ON.
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-47