Siemens Sinumerik 840D sl Diagnostic Manual page 657

03/2009
Component class:
1: Control Unit
2: Motor Module
3: Line Module
4: Sensor Module (SM)
5: Voltage Sensing Module (VSM)
6: Terminal Module (TM)
7: DRIVE-CLiQ Hub Module
8: Controller Extension 32 (CX32, NX10, NX15)
49: DRIVE-CLiQ components (non-listed components)
50: Option slot (e.g. Terminal Board 30)
60: Encoder (e.g. EnDat)
70: Motor with DRIVE-CLiQ
Component type:
Precise designation within a component class (e.g. "SMC20").
Connection number:
Consecutive numbers, starting from zero, of the appropriate connection or slot (e.g. DRIVE-CLiQ con-
nection X100 on the Control Unit has the connection number 0).
Remedy: Output the fault value and remove the specified connection.
Note:
Under "Topology --> Topology view" the commissioning software offers improved diagnostics capa-
bility (e.g. setpoint/actual value comparison).
201380 <location>Topology: Actual topology, defective EEPROM
Message Preliminary component number: %1
value:
Drive object: All objects
Reaction: NONE
Acknowledge: POWER ON
Cause: When detecting the actual topology, a component with a defective EEPROM was detected.
Fault value (r0949, interpret hexadecimal):
bbbbaaaa hex:
aaaa = preliminary component number of the defective components
Remedy: Output the fault value and remove the defected component.
201381 <location>Topology: Comparison power unit shifted
Message Component number: %1, Component class: %2, Component (target): %3, Connection number: %4
value:
Drive object: All objects
Reaction: NONE
Acknowledge: NONE
Cause: The topology comparison has detected a power unit in the actual topology that has been shifted with
respect to the target topology.
Alarm value (r2124, interpret hexadecimal):
ddccbbaa hex:
dd = connection number
cc = component number
bb = component class
aa = component number of the component shifted in the target topology
Note:
The connection in the actual topology where the shifted component was detected is described in dd,
cc and bb.
Component class and connection number are described in F01375.
The drive system is no longer booted. In this state, the drive control (closed-loop) cannot be enabled.
© Siemens AG 2009 All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
SINAMICS-Alarms
2-657