Siemens Sinumerik 840D sl Diagnostic Manual page 466

Overview of Alarms
NCK alarms
Remedy: Check parameter _STA2.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61129 [Channel %1: ] Block %2: perpendic. approach and retraction during
contour milling only allowed with G40
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE72.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61130 [Channel %1: ] Block %2: positions of parallel axes cannot be
compensated. No workpiece reference agreed.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE69.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61131 [Channel %1: ] Block %2: parameter _GEO incorrect, _GEO=%4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE69.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61132 [Channel %1: ] Block %2: Parallel axis parameters incorrect, check
values for parallel axis parameters ABS/INK
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE69.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61133 [Channel %1: ] Block %2: 3rd parallel axis parameter incorrect, check
axis name or GUD _SCW_N[]
Parameters: %1 = Channel number
%2 = Block number, label
2-466
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009