Siemens Sinumerik 840D sl Diagnostic Manual page 365

03/2009
22296 Channel %1 Spindle %2 Error on gear stage change (cause: error code
%3)
Parameters: %1 = Channel number
%2 = Axis name, spindle number
%3 = Error code
Definitions: An error occurred during gear stage change. The cause is specified by the error code.
Error codes:
- Error code 1 : internal use
- Error code 2 : internal use
- Error code 3 : internal use
- Error code 4 : internal use
- Error code 5 : Switchover to command axis not possible
- Error code 6 : Switchover to PLC axis not possible
- Error code 20 : internal use
- Error code 21 : internal use
- Error code 22 : internal use
- Error code 23 : MD 30132 IS_VIRTUAL_AX has been set
- Error code 50 : internal use
- Error code 51 : internal use
- Error code 70 : internal use
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Remedy conflict.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
22297 Channel %1 Spindle %2 FC18 function not possible (cause: error code
%3)
Parameters: %1 = Channel number
%2 = Axis name, spindle number
%3 = Error code
Definitions: The function request by PLC via FC18 interface could not be executed. The cause is specified by the
error code.
Error codes:
- Error code 1 : internal use
- Error code 2 : internal use
- Error code 3 : internal use
- Error code 4 : internal use
- Error code 5 : Switchover to command axis not possible
- Error code 6 : Switchover to PLC axis not possible
- Error code 20 : internal use
- Error code 21 : internal use
- Error code 22 : internal use
- Error code 23 : MD 30132 IS_VIRTUAL_AX has been set
- Error code 50 : internal use
- Error code 51 : internal use
- Error code 70 : internal use
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Remedy conflict.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
22320 [Channel %1: ] Block %2 PUTFTOCF command could not be transferred
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-365