Siemens Sinumerik 840D sl Diagnostic Manual page 460

Overview of Alarms
NCK alarms
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61101 [Channel %1: ] Block %2: Reference point defined incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63, CYCLE64, CYCLE71, CYCLE72, CYCLE81 to
CYCLE90, CYCLE840, SLOT1, SLOT2, POCKET1 to POCKET4, LONGHOLE.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: With an incremental specification of the depth, either different values have to be selected for the ref-
erence point (reference plane) and the retraction plane, or an absolute value must be specified for the
depth.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61102 [Channel %1: ] Block %2: No spindle direction programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63, CYCLE64, CYCLE86, CYCLE87, CYCLE88,
CYCLE840, POCKET3, POCKET4.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Parameter SDIR (or SDR in CYCLE840) must be programmed.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61103 [Channel %1: ] Block %2: Number of holes is zero
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No value for the number of holes has been programmed. Alarm triggered by following cycles:
HOLES1, HOLES2.
Remedy: Check parameter NUM.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61104 [Channel %1: ] Block %2: Contour violation of slots
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Incorrect parameterization of the milling pattern in the parameters which define the position of the
slots/elongated holes on the circle and their form. Alarm triggered by following cycles: SLOT1, SLOT2,
LONGHOLE.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61105 [Channel %1: ] Block %2: Milling cutter radius too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The diameter of the cutter used is too large for the form to be machined. Alarm triggered by following
cycles: SLOT1, SLOT2, POCKET1 to POCKET4, LONGHOLE, CYCLE90.
2-460
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009