Siemens Sinumerik 840D sl Diagnostic Manual page 85

03/2009
10207 [Channel %1: ] Error when selecting or deselecting the digitize function
Parameters: %1 = Channel number
Definitions: An error has occurred on activating/deactivating the digitizing module; e.g. not in channel ready state,
already activated, etc.
Reaction: Alarm display.
Remedy: Press RESET.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10208 [Channel %1: ] Continue program with NC start
Parameters: %1 = Channel number
Definitions: After block search with calculation, the control is in the desired state. The program can now be started
with NC Start or the state can be changed for the time being with overstore/jog.
Reaction: Interpreter stop
Alarm display.
NC Stop on alarm.
Remedy: Press NC Start.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10209 [Channel %1: ] Internal NC stop after block search
Parameters: %1 = Channel number
Definitions: Internal alarm which only initiates the alarm response NC Stop.
The alarm is output in the following situations:
- If MD11450 $MN_SEARCH_RUN_MODE, bit 0 ==1 and the last action block is loaded in the main
run after block search. Alarm 10208 is then activated as a function of the NC/PLC interface signal
DB21-30 DBX1.6 (PLC action finished).
- Search alarm 10208 has been suppressed by the PI service _N_FINDBL (third decade of the param-
eter supplied with "2"). Alarm 10209 is set as a function of whether or not a search ASUB has been
configured (MD11450 $MN_SEARCH_RUN_MODE bit 1) with the end of the search ASUB or the
loading of the last action block in the main run.
Reaction: Interpreter stop
NC Stop on alarm.
Remedy: NC-Start
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10222 [Channel %1: ] Inter-channel communication not possible
Parameters: %1 = Channel number
Definitions: This channel has received a negative acknowledgment from the inter-channel communication
because the destination channel number is not known, e.g.: START(x) or WAITE(x) but channel x has
not been initialized
Reaction: Alarm display.
Remedy: This is an indication of possible discrepancies. The program continues if no acknowledgment is called
for.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-85