Siemens Sinumerik 840D sl Diagnostic Manual page 474

Overview of Alarms
NCK alarms
Definitions: The alarm is triggerd by the following cycles: CYCLE832.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61196 [Channel %1: ] Block %2: No swiveling in JOG --> Multi-axis
transformations and TCARR activated at the same time
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Multi-axis transformations (TRAORI) and Toolcarrier (TCARR) activated at the same time.
Alarm triggered by following cycles: CYCLE800.
Remedy: Deselection of multi-axis transformation with TRAFOOF
or deselection of Toolcarrier (TCARR) with CYCLE800()
61197 [Channel %1: ] Block %2: Swiveling - plane not allowed -> Error code %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE800.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Error code:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61198 [Channel %1: ] Block %2: Swiveling with kinematic chain -> Error code:
%4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE800.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61199 [Channel %1: ] Block %2: Swiveling - tool not allowed -> Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: See error code for error cause. Alarm triggered by following cycles: CYCLE800.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Error code:
A: Orientation of tool and change of swivel data record not allowed
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61200 [Channel %1: ] Block %2: Too many elements in machining block
Parameters: %1 = Channel number
%2 = Block number, label
2-474
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009