Siemens Sinumerik 840D sl Diagnostic Manual page 488

Overview of Alarms
NCK alarms
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61264 [Channel %1: ] Block %2: Chained ShopTurn program blocks not
permissible in subprogram on pos. pattern
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If a subroutine is called from a position pattern, the subroutine itself must not include a position pattern.
Alarm triggered by following cycle: F_MANAGE.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Reprogram machining.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61265 [Channel %1: ] Block %2: Too many restrictions, use rectangular pocket
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In face milling a maximum of only 3 sides can be delimited.
Alarm triggered by following cycle: CYCLE61
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Use pocket cycle.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61266 [Channel %1: ] Block %2: Illegal machining direction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In face milling, the delimitations and the direction of machining do not match.
Alarm triggered by following cycle: CYCLE61
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select another direction of machining.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61267 [Channel %1: ] Block %2: Plane infeed too large, residual corners remain
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In face milling, the plane infeed must not exceed 85%.
Alarm triggered by following cycle: CYCLE61
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select a smaller plane infeed, as otherwise residual corners will be left over.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61268 [Channel %1: ] Block %2: Illegal machining direction, residual corners
are left over.
Parameters: %1 = Channel number
%2 = Block number, label
2-488
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009