Siemens Sinumerik 840D sl Diagnostic Manual page 471

03/2009
61179 [Channel %1: ] Block %2: character does not exist, no.: %4
Parameters: %1 = Channel number
%2 = Block number, label
%4 = Character number
Definitions: The character entered in the text for engraving cannot be milled.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter another character.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61180 [Channel %1: ] Block %2: No name assigned to swivel data record
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Although there are several swivel data blocks, no unique names have been assigned. Alarm triggered
by following cycles: CYCLE800.
Remedy: Assign unique name to swivel data block ($TC_CARR34[n]), if machine data 18088
$MN_MM_NUM_TOOL_CARRIER is >1.
61181 [Channel %1: ] Block %2: NCK software version is insufficient for the
Swivel function
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Swivelling is not possible with the current NCK software version. Alarm triggered by following cycles:
CYCLE800.
Remedy: Upgrade NCK software to NCK 75.00 or higher.
61182 [Channel %1: ] Block %2: Name of swivel data record unknown: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: the specified name of the swivel data block is unknown. Alarm triggered by following cycles:
CYCLE800.
Remedy: Check name of swivel data record $TC_CARR34[n].
61183 [Channel %1: ] Block %2: Swivel CYCLE800: Retraction mode parameter
lies outside value range: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The value of the retraction mode parameter (_FR) lies outside the valid range. Alarm triggered by fol-
lowing cycles: CYCLE800.
Remedy: Swivel CYCLE800: Check transfer parameter _FR. Value range 0 to 8
61184 [Channel %1: ] Block %2: No solution possible with current input angle
values
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The surface defined via the input angle cannot be processed with the machine. Alarm triggered by
following cycles: CYCLE800.
Remedy: -Check the angles entered for swiveling the machining plane: %4
-Parameter _MODE coding incorrect, e.g. rotation axis-wise YXY
61185 [Channel %1: ] Block %2: Invalid angular ranges of rotary axes in swivel
data record: %4
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-471