Siemens Sinumerik 840D sl Diagnostic Manual page 38

Overview of Alarms
NCK alarms
4112 Servo cycle changed to %1 ms
Parameters: %1 = String (new servo cycle time)
Definitions: For PROFIBUS/PROFINET only:
MD10060 $POSCTRL_SYSCLOCK_TIME_RATIO has been modified because of the modified DP
cycle in the SDB (MD10050 $SYSCLOCK_CYCLE_TIME).
Reaction: Alarm display.
Remedy: MD10060 $MN_POSCTRL_SYSCLOCK_TIME_RATIO RATIO has been modified.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
4113 Sysclock cycle changed to %1 ms
Parameters: %1 = String (new PLC cycle time)
Definitions: For PROFIBUS/PROFINET only:
MD10050 $SYSCLOCK_CYCLE_TIME has been modified because of the modified DP cycle in the
SDB.
Reaction: Alarm display.
Remedy: MD10050 $MN_SYSCLOCK_CYCLE_TIME has been modified.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
4114 Error in DP cycle of the SDB
Parameters: %1 = String (new PLC cycle time)
Definitions: For PROFIBUS/PROFINET only:
The DP cycle in the SDB contains an error and cannot be set. The default value of
MD10050$MN_SYSCLOCK_CYCLE_TIME is set.
Reaction: Alarm display.
Remedy: Correct the SDB
Program Con- Switch control OFF - ON.
tinuation:
4115 Time ratio communication to Ipo changed to %1
Parameters: %1 = String (new PLC cycle time)
Definitions: The value of the MD10072 $MN_COM_IPO_TIME_RATIO has been adapted. This can only occur, if
the value of the machine data is smaller than one and the time thus calculated is no multiple of the
position control cycle.
Reaction: Alarm display.
Remedy: The MD10072 $MN_COM_IPO_TIME_RATIO has been adapted. Please check to ensure that the
calculated value is correct.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
4150 [Channel %1: ] Invalid M function subprogram call configured
Parameters: %1 = Channel number
Definitions: MD10715 $MN_M_NO_FCT_CYCLE[n] or MD10718 $MN_M_NO_FCT_CYCLE_PAR contains
invalid configuration data: An M function, which is occupied by the system and cannot be replaced by
a subprogram call has been specified in MD10715 $MN_M_NO_FCT_CYCLE[n] for the configuration
of the subprogram call via M function:
- M0 to M5,
- M17, M30,
- M19, M40 to M45,
- M function for selecting spindle/axis mode according to MD20094
$MC_SPIND_RIGID_TAPPING_M_NR (default: M70),
- M functions for nibbling/punching as configured in MD26008 $MC_NIBBLE_PUNCH_CODE if acti-
vated by MD26012 $MC_PUNCHNIB_ACTIVATION.
- Also M96 to M99 for applied external language (MD18800 $MN_MM_EXTERN_LANGUAGE).
2-38
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009