Siemens Sinumerik 840D sl Diagnostic Manual page 501

03/2009
61346 [Channel %1: ] Block %2: Distance between starting point and measuring
point <=0
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE961.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: 840D:
- Parameter _SETV[0] or _SETV[1] is empty or less than 0.
840D sl:
- Parameter X1 or Y1 is empty or less than 0.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61347 [Channel %1: ] Block %2: Angle 1st edge - 2nd edge equals 0
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE961.
Remedy: Parameter following angle (_INCA) equals 0.
61348 [Channel %1: ] Block %2: Angle rel. to reference edge equals 0
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61349 [Channel %1: ] Block %2: Distance upper probe edge - measuring
position = 0 for tool radius measurement
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE971
Remedy: The distance between the upper and lower edges of the tool probe equals 0; relevant for radius mea-
surement.
For 840D: Check parameter _TP[x,9]
For 840D sl: Check setting data 54634 $SNS_MEA_TP_CAL_MEASURE_DEPTH
61350 [Channel %1: ] Block %2: Feed, speed not programmed for tool
measurement with rotating spindle
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycles: CYCLE971.
The measuring feed and/or spindle speed during tool measurement with rotating spindle is not spec-
ified in the GUD variable _MFS.
Remedy: Check parameter _MFS[0]
61351 [Channel %1: ] Block %2: Tool length or radius is 0
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE971.
For the active tool, the length or radius equal zero.
Remedy: Check length and radius of the active tool in the compensation data memory.
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-501