Siemens Sinumerik 840D sl Diagnostic Manual page 502

Overview of Alarms
NCK alarms
61352 [Channel %1: ] Block %2: Path for logfile not permitted
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE106.
The specified path for the log file is incorrect.
Remedy: Check parameter _PROTNAME[1]
61353 [Channel %1: ] Block %2: Path for logfile not found
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE106.
The specified directory does not exist or the specified path is incorrect.
Remedy: Check parameter _PROTNAME[1]
61354 [Channel %1: ] Block %2: File for logfile not found
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE106.
No name specified for the log file.
Remedy: Check parameter _PROTNAME[1]
61355 [Channel %1: ] Block %2: Incorrect file type for logfile
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE106.
The file extension for the log file is incorrect.
Remedy: Check parameter _PROTNAME[1]
61356 [Channel %1: ] Block %2: File for logfile is being used
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE106.
The log file is already used by an NC program.
Remedy: Check parameter _PROTNAME[1]
61357 [Channel %1: ] Block %2: No resources free
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE106.
Not enough NC memory space available.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Delete the files.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61358 [Channel %1: ] Block %2: Error during recording
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE106.
Internal error
Remedy: Call the hotline!
61359 [Channel %1: ] Block %2: - continue with RESET
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE106.
Internal error
2-502
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009