Siemens Sinumerik 840D sl Diagnostic Manual page 51

03/2009
4346 [Channel %1: ] Invalid geoaxis assignment in machine data %2[%3]
Parameters: %1 = Channel number
%2 = Name of machine data
%3 = Transformation number
Definitions: MD2.... $MC_TRAFO_GEOAX_ASSIGN_TAB_... contains an invalid entry. The following causes for
the error are possible:
- The entry references a channel axis which does not exist.
- The entry is zero (no axis) but the transformation needs the relevant axis as a geometry axis.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Correct the entry in MD2.... $MC_TRAFO_GEOAX_ASSIGN_TAB_ or MD2....
$MC_TRAFO_AXES_IN_.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
4347 [Channel %1: ] Invalid channel axis assignment in machine data %2[%3]
Parameters: %1 = Channel number
%2 = Name of machine data
%3 = Transformation number
Definitions: MD2.... $MC_TRAFO_AXIS_IN_... contains an invalid entry. The following causes for the error are
possible:
- The entry refers to a channel axis which does not exist.
- The entry is zero (no axis) but the transformation needs the relevant axis as a channel axis.
- More than one external axis has been entered in MD2.... $MC_TRAFO_AXIS_IN_... for the 7-axis
transformation.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Correct the entry in MD2.... $MC_TRAFO_AXES_IN_...
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
4348 [Channel %1: ] Block %5 Configuration error %6 in transformation
$NT_NAME[%3] = '%2'.
Parameters: %1 = Channel number
%2 = Name of the transformation data record
%3 = Index of the transformation data record
%4 = Block number, label|error number
Definitions: The transformation data record is incorrect. The error cause is defined in detail by the following error
number:
- 1. The machine kinematics have not been defined, i.e. neither $NT_TOOL_CHAIN[n,0} nor
$NT_PART_CHAIN[n,0] refer to kinematic chains.
- 2. The kinematic chain with the name contained in $NT_T_CHAIN_NAME[n] could not be found.
- 3. The kinematic chain element with the name contained in $NT_T_CHAIN_1ST_ELEM[n] could
not be found.
- 4. The kinematic chain element with the name contained in $NT_T_CHAIN_LAST_ELEM[n] could
not be found.
- 5. The kinematic chain with the name contained in $NT_P_CHAIN_NAME[n] could not be found.
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-51