Siemens Sinumerik 840D sl Diagnostic Manual page 480

Overview of Alarms
NCK alarms
61230 [Channel %1: ] Block %2: Tool probe diameter too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool probe has not been calibrated correctly.
Alarm triggered by following cycles: E_MT_CAL, E_MT_RAD, E_MT_LEN.
Remedy: 840D:
Check the following variables in data block E_MESS_MT_DR[n] or E_MESS_MT_DL[n] for probe n+1
840D sl:
Check the following machine data: 51778 $MNS_J_MEA_T_PROBE_DIAM_LENGTH[n] or 51780
$MNS_J_MEA_T_PROBE_DIAM_RAD[n] for probe n+1
61231 [Channel %1: ] Block %2: ShopMill program %4 not executable, as not
tested by ShopMill
Parameters: %1 = Channel number
%2 = Block number, label
%4 = Program name
Definitions: Before a ShopMill program can be executed, it has to be tested by ShopMill.
Alarm triggered by following cycle: E_HEAD.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: The program first has to be simulated in ShopMill or loaded into the operating mode "Machine auto"
by ShopMill.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61232 [Channel %1: ] Block %2: Impossible to load magazine tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Only manual tools may be loaded into a swivel head in which only manual tools can be loaded.
The alarm is triggered by the following cycles: E_TD, E_TFS, F_TFS
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Load a manual tool into the swivel head or set the parameter "Tool change" in the start-up screen form
"Rotary axes" to "Automatic".
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61233 [Channel %1: ] Block %2: Thread angle wrongly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The thread angles were specified too large or too small.
Alarm triggered by following cycles: E_TR_CON, F_TR_CON
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check thread geometry.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61234 [Channel %1: ] Block %2: ShopMill subroutine %4 cannot be executed, as
not tested by ShopMill
Parameters: %1 = Channel number
%2 = Block number, label
%4 = Subroutine name
2-480
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009