Siemens Sinumerik 840D sl Diagnostic Manual page 259

03/2009
16697 [Channel %1: ] Block %2 following axis/spindle %3 coupling has not
been defined.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: An instruction to an undefined coupling is to be executed.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part programm.
Define the coupling and activate, if necessary, before the instruction.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16698 [Channel %1: ] Block %2 following axis/spindle %3 leading axis/spindle
%4 has not been defined.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Axis name, spindle number
Definitions: An instruction to an undefined leading axis/spindle of a coupling is to be executed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part programm.
Define the leading axis/spindle and activate, if necessary, before the instruction.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16699 [Channel %1: ] Block %2 following axis/spindle %3 leading axis/spindle
%4 has not been defined.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Axis name, spindle number
Definitions: An instruction to an undefined leading axis/spindle of a coupling is to be executed.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part programm.
Define the leading axis/spindle and activate, if necessary, before the instruction.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16700 [Channel %1: ] Block %2 axis %3 invalid feed type
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: In a thread cutting function, the feed has been programmed in a unit that is impermissible.
G33 (thread with constant lead) and the feed have not been programmed with G94 or G95.
G33 (thread with constant lead) is active (modal) and G63 is programmed additionally in a following
block. (Conflict situation! G63 is in the 2nd G group, G33, G331 and G332 are in the 1st G group).
G331 or G332 (rigid tapping) and the feed have not been programmed with G94.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Use only the feed type G94 or G95 in the thread cutting functions.
After G33 and before G63, deselect the thread cutting function with G01.
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-259