Siemens Sinumerik 840D sl Diagnostic Manual page 468

Overview of Alarms
NCK alarms
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61138 [Channel %1: ] Block %2: parameter %4 incorrectly defined for tool
monitoring in cycles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61139 [Channel %1: ] Block %2: error in function Tool monitoring in cycles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE69.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61150 [Channel %1: ] Block %2: Tool cannot be aligned --> error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Remedy: Causes of error:
1st error code = A -> only new swivel plane permitted, see parameter _ST
61151 [Channel %1: ] Block %2: Orientation of tool not possible --> error code:
%4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Remedy: Causes of error:
1st error code = A -> only additive swivel plane permitted, see parameter _ST
61152 [Channel %1: ] Block %2: B axis kinematics (turning technology) either
not or incorrectly set up in Start-up of swivel cycle --> error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Remedy: Causes of error:
1st error code = A123 -> B axis not an automatic rotary axis under ShopTurn (123 corresponds to
parameter _TCBA)
2nd error code = B123 -> B axis not activated in swiveling start-up (kinematics)
61153 [Channel %1: ] Block %2: No 'Rotary axes direct' swivel mode possible -
-> error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
2-468
(123 corresponds to $TC_CARR37[n], n ... number of the swivel data record)
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009