Siemens Sinumerik 840D sl Diagnostic Manual page 491
Hide thumbs
Also See for Sinumerik 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
03/2009
Definitions:
Tool diameter larger than delimitation.
Alarm triggered by following cycle: CYCLE61.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Use a smaller tool.
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61278
[Channel %1: ] Block %2: If tool angle is larger than 90°, both tool
diameters must be equal
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
For tool angles larger than 90°, the two tool diameters must be identical.
Alarm triggered by following cycle: CYCLE61.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Correct the tool angle or the tool diameters.
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61279
[Channel %1: ] Block %2: If tool angle equals 90°, both tool diameters
must be equal
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
For tool angles equal to 90°, the two tool diameters must be identical.
Alarm triggered by following cycle: CYCLE61.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Correct the tool angle or the tool diameters.
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61280
[Channel %1: ] Block %2: Mirroring in WO %4 missing
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
If the program starts with a counterspindle movement, a work offset with mirroring will have to be
selected.
Alarm triggered by following cycle: F_SUB_SP
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Select the mirroring for the work offset used.
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61281
[Channel %1: ] Block %2: starting point of machining outside retraction
planes
Parameters:
%1 = Channel number
%2 = Block number, label
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-491
Hide quick links:
Advertisement
Table of Contents
