Siemens Sinumerik 840D sl Diagnostic Manual page 223

03/2009
27 ProgAccel option
33 AllAsupSynact option
34 CmdAxSpind option
35 Mea2 option
36 ProgAnaOut option
37 OptAaTOff option
41 MachineMaintenance option
42 PathFeedSAInput option
45 ElecTransfer option
46 Cut3D option
47 CDA option
48 Reserved: generic coupling option
49 Measuring cycles option
50 ForceControl option
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program, retrofit option.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14782 [Channel %1: ] Block %2 non-active function used (identification %3)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Fine ID
Definitions: A non-active function is used in the block
Brief description of the identification
1 Transformation
2 H number of the tool
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: - Modify part program.
- Activate function.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14783 [Channel %1: ] Block %2 coordinate system-specific working area
limitation is not active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An attempt is made in the block to activate a group of the coordinate system-specific working area
limitation.
However, this group is not set up (see MD28600 $MC_MM_NUM_WORKAREA_CS_GROUPS).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
The NC program is stopped. The G code of the group WALCS01 - WALCS10 can be changed.
Remedy: - Modify part programm.
- Activate more coordinate system-specific working area limitations.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14790 [Channel %1: ] Block %2 axis %3 programmed by PLC
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis
Definitions: In the NC block, an axis has been programmed that is already being traversed by the PLC.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-223