Siemens Sinumerik 840D sl Diagnostic Manual page 487

03/2009
Definitions: The program has been created with a ShopMill version that is higher than the existing one.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Delete the machining step and reprogram machining if required.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61260 [Channel %1: ] Block %2: program contains new machining steps from
ShopTurn %4
Parameters: %1 = Channel number
%2 = Block number, label
%4 = ShopTurn version
Definitions: The program has been created with a ShopMill version that is higher than the existing one.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Delete the machining step and reprogram machining if required.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61261 [Channel %1: ] Block %2: center offset too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The center offset on center drilling is larger than permissible.
Alarm triggered by following cycles: F_DRILL, F_DRILLD.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter smaller center offset (see display machine data 9862).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61262 [Channel %1: ] Block %2: pitch not possible with selected tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The pitch of the tap does not match the programmed pitch.
Alarm triggered by following cycles: F_DR_TAP, F_DRM_TA, F_TAP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Use a tap with the programmed pitch.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61263 [Channel %1: ] Block %2: Chained ShopMill program blocks not
permissible in subprogram on pos. pattern
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If a subroutine is called from a position pattern, the subroutine itself must not include a position pattern.
The alarm is triggered by the following cycle: E_MANAGE
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Reprogram machining.
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-487