Siemens Sinumerik 840D sl Diagnostic Manual page 252

Overview of Alarms
NCK alarms
16510 [Channel %1: ] Block %2 no facing axis for diameter programming
available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Diameter programming has been activated although no transverse axis with diameter programming
has been applied.
Transverse axes can be applied with MD20100 $MC_DIAMETER_AX_DEF or MD30460
$MA_BASE_FUNCTION_MASK bit2 for diameter programming.
Diameter programming can be applied through:
- basic position DIAMON or DIAM90 of the G 29 group during booting
- programming of DIAMON or DIAM90
- programming of DIAMONA[AX], DIAM90A[AX] or DAC, DIC, RAC, RIC
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
When programming DIAMON/DIAM90, a traverse axis must be configured via MD20100
$MC_DIAMETER_AX_DEF.
When programming DIAMONA[AX], DIAM90A[AX] or DAC, DIC, RAC, RIC, the AX axis must be a
transverse axis for diameter programming configured via MD30460 $MA_BASE_FUNCTION_MASK
bit2.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16520 [Channel %1: ] Axis %2, diameter programming active, function %3 is not
executed
Parameters: %1 = Channel
%2 = Axis, spindle
%3 = NC function
Definitions: The function is not executed with diameter programming active for the stated axis.
The following functions may be affected:
1 - Axis exchange
2 - Axis container rotation
Reaction: Interpreter stop
Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Disable diameter programming of the axis before activating the function.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16600 [Channel %1: ] Block %2 spindle %3 gear stage change not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Spindle number
Definitions: The programmed speed is outside the speed range of the set gear stage. In order to execute the pro-
grammed speed, the gear stage must be changed. In order to be able to execute the automatic gear
stage change (M40 is active), the spindle must be in speed control operation.
The alarm will no longer be output after having set bit 30 (0x40000000) in MD11410
$MN_SUPPRESS_ALARM_MASK. However, the function will not be affected by this.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: The changeover to speed control operation is performed by programming M3, M4 or M5. The M func-
tions can be written together with the S word in the same block.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
2-252
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009