Siemens Sinumerik 840D sl Diagnostic Manual page 329

03/2009
20085 [Channel %1: ] Contour handwheel: traverse direction or overtravel of
beginning of block not allowed
Parameters: %1 = Channel number
Definitions: Travel takes place on the path with the contour handwheel in the opposite direction to the programmed
travel direction and the starting point of the path has been reached at the start of the block.
Reaction: Alarm display.
Remedy: Turn the contour handwheel in the opposite direction.
Program Con- Alarm display showing cause of alarm disappears. No further operator action necessary.
tinuation:
20090 Axis %1 travel to fixed stop not possible. Check programming and axis
data.
Parameters: %1 = Axis name, spindle number
Definitions: 1. The "Traverse against fixed stop" function has been programmed with FXS[AX]=1 but the axis does
not (yet) support this. Check MD37000 $MA_FIXED_STOP_MODE. This function is not available for
gantry axes and simulated axes.
2. On selection, no movement was programmed for axis AX. AX is a machine axis identifier.
3. It is always necessary to program a traversing movement in the selection block for the axis/spindle
for which the "Traverse against fixed stop" function is activated.
The alarm can be reprogrammed in the MD11412 $MN_ALARM_REACTION_CHAN_NOREADY
(channel not ready).
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Channel not ready.
Remedy: Please inform the authorized personnel/service department.
- Check the axis type.
- Check MD37000 $MA_FIXED_STOP_MODE.
- Is a machine axis movement missing in the approach block?
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
20091 Axis %1 has not reached fixed stop
Parameters: %1 = Axis name, spindle number
Definitions: On attempting to traverse against a fixed stop, the programmed end position has been reached or the
traversing movement has been aborted. The alarm can be concealed by means of the MD37050
$MA_FIXED_STOP_ALARM_MASK.
The alarm can be reprogrammed in the MD11412 $MN_ALARM_REACTION_CHAN_NOREADY
(channel not ready).
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Channel not ready.
Remedy: Correct the part program and the settings:
- Has the traversing block been aborted?
- If the axis position does not correspond to the programmed end position, then correct the end posi-
tion.
- If the programmed end position is in the part, the triggering criterion must be checked.
- Has the contour deviation leading to triggering been dimensioned too large? Has the torque limit
been set too high?
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-329