Siemens Sinumerik 840D sl Diagnostic Manual page 505

03/2009
61401 [Channel %1: ] Block %2: Probe does not switch, traversing path limited
by software limit position.
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE961, CYCLE971, CYCLE976, CYCLE977,
CYCLE978, CYCLE998
Remedy: The position defined by a setpoint value cannot be reached as this would mean overrunning the soft-
ware limit position.
- Check specified setpoint value.
61402 [Channel %1: ] Block %2: Probe collision, traversing path limited by
software limit position
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: CYCLE977
Remedy: For the measuring variants Measure web/shaft, the position path in the plane was limited by the soft-
ware limit position. The probe switched in the following infeed along the infeed axis.
Check programmed position of software limit position.
61403 [Channel %1: ] Block %2: Work offset correction not executed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Call the SIEMENS hotline
61404 [Channel %1: ] Block %2: Tool correction not executed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check the dependent tool specifications.
61405 [Channel %1: ] Block %2: Tool environment does not exist
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Correct the name of the tool environment (_TENV) or create this environment.
61406 [Channel %1: ] Block %2: Check DL number
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: For 840D: Check parameter _DLNUM
For 840D sl: Check parameter DL
Check the number of the sum offset and that of the setup offset.
61407 [Channel %1: ] Block %2: Check 7th digit and higher of _KNUM
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check parameter _KNUM.
Check the the number of the sum offset and that of the setup offset.
61408 [Channel %1: ] Block %2: total offsets not present
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Set MD 18080, Bit 8=1
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-505