5
INDICATION AND DISPLAY
The transceiver has the following indicator and display.
•
LED (TX/ Busy)
•
LCD
•
Selective Call Alert LED
Note
No LCD is equipped with NX-200S/ NX-300S. The content regarding the LCD display in each description below is not applicable for
NX-200S/ NX-300S.
5.1
Busy LED
Busy LED is used to notify a user visually that the transceiver has received a signal.
The LED lights green while the transceiver is receiving a signal in a Conventional Group.
The LED lights only when the transceiver is on a traffic channel in an NXDN Trunking system. The Busy LED does not light
when the transceiver is on a control channel.
Also, whether the Busy LED will light while the transceiver receives in Emergency Mode can be configured. (Refer to
Emergency LED on page
402.)
Configuration using KPG-111D/ DN
Configuring whether the Busy LED will light (
5.2
Transmit LED
Transmit LED is used to notify a user visually that the transceiver is transmitting.
The Transmit LED lights red while the transceiver is transmitting.
Also, whether the Transmit LED will light while the transceiver transmits in Emergency Mode can be configured. (Refer to
Emergency LED on page
402.)
Configuration using KPG-111D/ DN
Configuring whether the Transmit LED will light (
FUNC (K)/Ver 4.00
See
FPRG 8.10.3 Common Page 3 Tab)
See
FPRG 8.10.3 Common Page 3 Tab)
CONTENTS
INDEX
72