About Communication Methods - Kenwood NEXEDGE NX-200 Function Reference

About Communication Methods

Also, the system to be used in each zone can be configured by selecting a system from the multiple systems, system 1 to
8. A user can change a system to be used by switching a zone. (Refer to
In this document, the conventional method to operate the transceiver by using only a single system is referred to as "single
system". The method to operate the transceiver by using the multiple systems is referred to as "multiple systems".
About Communication Methods
Following are the communication methods that the transceiver can use.
Communication Method
Voice calls using an NXDN
ID
Data communications using
an NXDN ID
Communications using an
LTR ID
Voice calls using a
FleetSync ID
Data communications using
a FleetSync ID
Data communications using
the MDC-1200 format
Individual calls using an
Optional Signaling
Direct communications
between transceivers (Talk
Around)
FUNC (K)/Ver 4.00
Description
The transceiver can make following individual or group calls by using
an NXDN ID.
• Individual Call
• Group Call
• Broadcast Group Call
The transceiver can make the following data communications by using
an NXDN protocol.
• Status Call
• Short Data Call
• Long Data Call
The transceiver can communicate using an LTR ID.
The transceiver can make following voice calls by using a FleetSync
ID.
• Individual Call
• Group Call
• Fleet Call
• Supervisor Call
• Broadcast Call
The transceiver can make the following data communications by using
an FleetSync ID.
• Status Message Call
• Short Message Call
• Long Message Call
The transceiver can use following functions by using the MDC-1200
format.
• PTT ID Encode/ Decode
• Emergency Encode/ Decode
• Radio Check
• Stun
The transceiver can make an individual call by using following
Optional Signalings.
• DTMF
• 2-tone (NX-200/ NX-200S/ NX-210/ NX-300/ NX-300S/
NX-700/ NX-700H/ NX-800/ NX-800H only)
• FleetSync ID
• NXDN ID
The transceiver can communicate directly with a target transceiver by
using the Talk Around function when the transceiver is operated via a
repeater.
9 NXDN TRUNKING SYSTEM on page
Available System
NXDN Trunking System
NXDN Conventional System
NXDN Trunking System
NXDN Conventional System
LTR Trunking System
Analog Conventional System
LTR Trunking System
Analog Conventional System
LTR Trunking System
Analog Conventional System
LTR Trunking System
Analog Conventional System
NXDN Conventional System
LTR Trunking System
• 2-tone and FleetSync can be
used only in an Analog
Conventional system.
• NXDN ID can be used only in
an NXDN Conventional
system.
Analog Conventional System
NXDN Conventional System
LTR Trunking System
CONTENTS
187.)
INDEX xvi