Kenwood NEXEDGE NX-200 Function Reference page 203

8 NXDN CONVENTIONAL SYSTEM
8.11 Sending and Receiving a Long Message (Long Data Call)
Configuration using KPG-111D/ DN
Configuring the Short Message Serial Output to be enabled or disabled (
8.11 Sending and Receiving a Long Message (Long Data Call)
Long Data Call can be used to send and receive a maximum of 4,096 characters (Long Message).
Using this function, information can reliably be sent to the target party.
Note
• To send a Long Message, "Data" or "Data + GPS Data Output" must be configured for the communication port of the transceiver.
(Refer to Available Functions for COM Port on page
• This section describes information for both an NXDN Conventional system and NXDN Trunking system.
Sending a Long Message
A Long Message is sent via a PC. A Long Message cannot be sent from the transceiver.
Transceiver Behavior
1
A PC sends the PC command to the transceiver to request transmission of a Long Message.
The transceiver starts sending the Long Message.
If the Long Message is properly sent to the receiving transceiver,
"COMPLETE" appears.
Note
For details on the information displayed on the main display during transmission in an NXDN Trunking system, refer to
during transmission on page
FUNC (K)/Ver 4.00
524.)
207.
See FPRG 8.10.6 Common Page 4 Tab)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS
 Display
INDEX 169