Using The Transceiver As A Megaphone (Public Address) (Mobile Only) - Kenwood NEXEDGE NX-200 Function Reference

6 SOUND

6.5 Using the Transceiver as a Megaphone (Public Address) (Mobile Only)

6.5 Using the Transceiver as a Megaphone (Public Address)
(Mobile Only)
Public Address enables the transceiver to be used in place of a megaphone.
Pressing and holding the PTT switch while Public Address is enabled causes the audio spoken into the microphone to emit
from the external speaker for Public Address that is connected to the rear panel of the transceiver.
Operating the Transceiver
 Enabling the Public Address
1
Press the Public Address
Public Address is enabled. "PA" appears on the sub-display.
 Disabling the Public Address
1
Press the Public Address
Public Address is disabled. "PA" on the sub-display disappears.
Note
• Pressing the Menu key causes the transceiver to enter Menu Mode, and then the status of Public Address can be toggled between
enabled and disabled by selecting "Public Address". (Refer to
• Public Address will automatically be disabled if the channel or GID is changed.
• To use Public Address, an optional KAP-2 and external speaker for Public Address are required.
• In an NXDN Trunking system (Message Trunked (Enhanced)), Public Address is disabled when the reception of a call is initiated by
using a traffic channel, such as an Individual Call, Group Call, and Broadcast Group Call. On the other hand, even if the transceiver
receives a call initiated by using only a control channel such as a Status Call and Short Data Call, Public Address will not be disabled.
Configuration using KPG-111D/ DN
Assigning functions to the PF keys on the transceiver (
FUNC (K)/Ver 4.00
key while Public Address is disabled.
key while Public Address is enabled.
3.4 Using Menu Mode on page
See
23.)
FPRG 8.12 Key Assignment Window)
CONTENTS INDEX 96