Kenwood NEXEDGE NX-200 Function Reference page 259

9 NXDN TRUNKING SYSTEM
9.8 Making a Group Call with the Link to a Traffic Channel Retained (Message Trunked (Enhanced))
Configuration
If transmission is inhibited on a traffic channel when the transceiver initiates a transmitting using Group Call in an
Enabled NXDN Trunking system, the transmission behavior is not retained and the transmission ends immediately. While
pressing the PTT switch, the Warning Tone A sounds from the transceiver and transmission cannot be initiated.
If transmission is inhibited on a traffic channel when the transceiver initiates a transmitting using Group Call in an
NXDN Trunking system, the transmission behavior is maintained until the transmission is possible. While
Disabled
pressing the PTT switch, the transmission behavior is maintained. Pressing and holding the PTT switch,
transmission will initiate if transmission becomes possible.
Note
• The transmission behavior is maintained regardless of the PTT Hold Inhibit configuration in Emergency Mode.
• This function can be used with the Group Call (Message Trunked (Enhanced)).
Configuration using KPG-111D/ DN
Configuring PTT Hold Inhibit to be enabled or disabled (
9.8 Making a Group Call with the Link to a Traffic Channel
Retained (Message Trunked (Enhanced))
Group Call (Message Trunked (Enhanced)) is the function that allows you to establish two-way group voice
communications by initiating a call to a group. Using the Group Call (Message Trunked (Enhanced)) function,
communications can be started without reestablishing a link between the transceiver and a traffic channel to respond to a
call, as the link to the traffic channel has been maintained. This enables the occupation of a traffic channel assuring the
continuity of communications without facing the busy channel to respond to a call. The traffic channel can be released by
the transceiver operation.
To use this function, "Message Trunked (Enhanced)" needs to be configured for Trunking Type on both the transmitting
transceiver and the receiving transceiver using KPG-111D/ DN. "Message Trunked (Enhanced)" also needs to be
configured for Trunking Type on the system. (Refer to
Note
For Group Call (Message Trunked (Enhanced)), the following functions used for a normal Group Call are available. (Refer to
Making a Group Call (Transmission Trunked) on page
• Group Call Display Type
• Call Alert Inhibit (Group Calls Only)
• Ignore Group Call during Individual Call
• PTT Hold Inhibit
Initiating a Group Call (Message Trunked (Enhanced))
Group Call (Message Trunked (Enhanced)) can be initiated by pressing the CH/GID Up key or the CH/GID Down key to
select a Group ID, and then pressing the PTT switch.
Note
A Group Call (Message Trunked (Enhanced)) cannot be initiated by using a PC command.
FUNC (K)/Ver 4.00
Table 9-7 PTT Hold Inhibit
Description
See FPRG 8.19.4 Trunking Tab)
Trunking Type on page
220.)
203.)
CONTENTS INDEX
9.7
225