Target Fleet/ Id; Status 80 - 99 (Special); Emergency Status Response - Kenwood NEXEDGE NX-200 Function Reference

12 FleetSync
12.6 Sending and Receiving a Status Message (Status Call)

Target Fleet/ ID

Target Fleet/ ID is the target FleetSync ID used for sending the following Status Messages or Short Messages:
• AUX Input Status Message (Mobile only)
• Power-on Status Message
• Power-off Status Message
• A Status Message that is sent by selecting a status number or directly entering a status number after the
transceiver enters Status Mode by a user pressing the Status (FleetSync/NXDN) key or the [0] to [9] keys on the
keypad
• A Status Message that is sent by selecting a status number or directly entering a status number after the
transceiver enters Status Mode by a user selecting "Status (FleetSync/NXDN)" from Menu Mode
• A Status Message that is sent by a user pressing the Call key
• A Short Message that is sent by entering a text string after the transceiver enters Short Message Mode by a user
pressing the SDM (FleetSync/NXDN) key or the [0] to [9] keys on the keypad
• A Short Message that is sent by entering a text string after the transceiver enters Short Message Mode by a user
selecting "SDM (FleetSync/NXDN)" from Menu Mode
Target FleetSync ID can be configured using KPG-111D/ DN. FleetSync ID of the base station which is responsible for
operation and administration is normally configured for Target Fleet/ ID (Status Message).
Configuration using KPG-111D/ DN
Configuring the Target Fleet/ID (

Status 80 - 99 (Special)

Status 80 - 99 (Special) is the function used to prevent a user from sending the reserved status numbers 80 to 99
erroneously.
Note
This function is unavailable for NX-200S/ NX-300S.
Configuration using KPG-111D/ DN
Configuring the Status 80 - 99 (Special) (

Emergency Status Response

Emergency Status Response is the function to make an Alert Tone sound when the transceiver receives an Emergency
Status.
"MAN DOWN" appears on the main display when the transceiver receives Status 98. "EMERGENCY" appears on the main
display when the transceiver receives Status 99. However, the configured data appears if the Emergency Status is
configured in the Status List.
Emergency Status Response can be configured by using KPG-111D/ DN.
Configuration
None The transceiver functions in the same manner as when receiving a normal status.
The Alert Tone configured for Emergency Response sounds from the transceiver when receiving an Emergency
Alert
Status.
If receiving an Emergency Status, the Alert Tone configured for Emergency Response sounds from the transceiver
*1
Horn
and the Horn Alert port is activated.
*1
Mobile only
FUNC (K)/Ver 4.00
See FPRG 8.16.7 Target Tab)
FPRG 8.16.2 General 1 Tab)
See
Table 12-16 Emergency Status Response
Description
CONTENTS INDEX 334