Kenwood NEXEDGE NX-200 Function Reference page 264

9 NXDN TRUNKING SYSTEM
9.10 Common Functions for Data Communications
Transceiver Behavior
1
The transceiver receives a Broadcast Group Call.
Alert Tone (Broadcast Group Call) sounds from the transceiver,
and then the received Group ID, or the Unit ID of the transmitting
transceiver, or both will appear. (Refer to
Transceiver Receives a Group Call (Group Call Display Type) on
page 223.)
Note
A user cannot reply to the received Group ID. Pressing the PTT switch causes "RECEIVE ONLY" to appear on the transceiver main
display.
9.10 Common Functions for Data Communications
The following functions are used in common for data communications such as Status Call or Short Data Call, Long Data
Call data transmission.
• Number of Retries
• Transmit Busy Wait Time
• Maximum ACK Wait Time
• Message Display Type
Number of Retries
If the transceiver does not receive the acknowledgment after the transceiver sends data and the time configured for
Maximum ACK Wait Time elapses, the transceiver resends data. Number of Retries is the number of times for the
transceiver to resend data. A smaller number can be configured if there is good communicating conditions, and a larger
number can be configured if there are inferior communicating conditions.
Configuration using KPG-111D/ DN
Configuring the Number of Retries (
Transmit Busy Wait Time
The transceiver confirms that the traffic channel is available before sending data and then starts sending data when the
channel is available. Transmit Busy Wait Time is the duration to wait for the traffic channel to become available.
A transmission is canceled when the channel is busy and the Transmit Busy Wait Time elapses.
The default configuration is normally used.
Configuration using KPG-111D/ DN
Configuring the Transmit Busy Wait Time (
FUNC (K)/Ver 4.00
Display When the
See FPRG 8.19.2 General 1 Tab)
FPRG 8.19.2 General 1 Tab)
See
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS INDEX 230