Aux Output Status Message - Kenwood NEXEDGE NX-200 Function Reference

8 NXDN CONVENTIONAL SYSTEM
8.9 Sending and Receiving a Status Message (Status Call)
Emergency Status Response
Emergency Status Response is the function to make an Alert Tone sound when the transceiver receives an Emergency
Status.
In the case that the Man-down tilt switch on the transmitting transceiver is switched On which results in the transceiver
entering Emergency Mode, then "MAN DOWN" appears on the main display of the receiving transceiver when it receives
the signal. In the case that the transmitting transceiver enters Emergency Mode activated by the Emergency key or a foot
switch, then "EMERGENCY" appears on the main display of the receiving transceiver when it receives the signal.
Emergency Status Response can be configured by using KPG-111D/ DN.
Configuration
None The transceiver functions in the same manner as when receiving a normal status.
The Alert Tone configured for Emergency Response sounds from the transceiver when receiving an
Alert
Emergency Status.
If receiving an Emergency Status, the Alert Tone configured for Emergency Response sounds from the
*1
Horn
transceiver and the Horn Alert port is activated.
*1
Mobile only
Configuration using KPG-111D/ DN
Configuring the Emergency Status Response (
AUX Input Status Message (Mobile Only)
AUX Input Status Message can be used to send the specified Status Message when the AUX Input port goes high level to
low level or goes low level to high level.
The transceiver can send a Status Message when a sensor is attached to the AUX Input port and the status of the AUX
Input port changes. The target ID is the ID configured for the Base ID. (Refer to
To use this function, AUX Input Status Message must be assigned to one of AUX Input ports.
Configuration using KPG-111D/ DN
• Configuring the AUX Input Status Message (
• Assigning functions to AUX Input (
AUX Output Status Message (Mobile Only)
AUX Output Status Message is the function to switch the status of the AUX Output port from high to low or from low to high
when the transceiver receives the specified Status Message. This function can be used to remotely turn the external
device On or Off.
To use this function, AUX Output Status Message must be assigned to one of AUX Output ports.
Configuration using KPG-111D/ DN
• Configuring the AUX Output Status Message (
• Assigning functions to AUX Output (
FUNC (K)/Ver 4.00
Table 8-15 Emergency Status Response
Description
FPRG 8.19.2 General 1 Tab)
See
See FPRG 8.19.9 Status Tab)
See FPRG 8.30.2 AUX Tab)
FPRG 8.19.9 Status Tab)
See
FPRG 8.30.2 AUX Tab)
See
Base ID on page 160.)
CONTENTS INDEX 161