Getting Started; Connecting The Transceiver To A Pc - Kenwood NEXEDGE NX-200 Function Reference

2

GETTING STARTED

When the transceiver is turned ON after the power source is attached to the transceiver, the transceiver starts up. To make
the transceiver ready for use, the configuration data needs to be created using KPG-111D/ DN and written to the
transceiver.
By using KPG-111D/ DN, the zone and channel data needs to be configured and then the parameters for various functions
can be configured. Refer to FPRG for configuration methods.
2.1

Connecting the Transceiver to a PC

To write the configuration data to or read the configuration data from the transceiver, the transceiver and a PC with
KPG-111D/ DN installed need to be connected by using the programming cable.
Portable
The transceiver and a PC need to be connected by using the KPG-36A or KPG-36U programming cable.
Refer to the figure below.
 Using the KPG-36A
Note
If no RS-232C communication port is available on a PC, convert by using KCT-53U the USB port on the PC to DB 9-pin, and then
connect the KPG-36A.
FUNC (K)/Ver 4.00
Figure 2-1 KPG-111D/ DN Main Window
KPG-36A
To the
Universal Connector
To RS-232C Port
(D-sub 9-pin male)
CONTENTS INDEX 10