Kenwood NEXEDGE NX-200 Function Reference page 515

22 FUNCTION PORTS
22.2 D-sub 25-pin Connector (Mobile Only)
without Alert Tone
without Alert Tone can be used to configure the transceiver not to emit the alert tone even if the activation conditions for the
vibrator are satisfied and the vibrator is activated. (Refer to
If an Alert Tone sounds from the transceiver in quiet environments, it may bother other people. In this case, the transceiver
can be configured to mute Alert Tones and a user can recognize the reception of a call or message only from the vibration
of the vibrator.
After disabling this function, the vibrator vibrates and Alert Tones sounds if the activation conditions for the vibrator are
satisfied. However, a user may not recognize a call or message is being received only from the vibration of the vibrator. In
this case, an Alert Tone notifies a user that a call or message is being received.
Configuration using KPG-111D/ DN
Configuring the without Alert Tone to be enabled or disabled (
22.2 D-sub 25-pin Connector (Mobile Only)
For Mobile, the transceiver is equipped with function ports (AUX Input/ AUX Output) that can be programmed for use with
the D-sub 25-pin connector located on the rear panel of the transceiver.
Available Functions for AUX Input Ports
This section describes each function that can be assigned to AUX Input ports.
Depending on a function assigned to an AUX input port, the function will immediately be activated if the AUX input port is
active when the transceiver is turned ON. In addition, depending on a function assigned to an AUX input port, the function
will not be activated when the transceiver is in the Stun state. Refer to the following table for how the function behaves
depending on the transceiver status.
Table 22-3 Behavior of Each Function Depending on the Transceiver Status
External PTT (Voice)
External PTT (Data)
Data PTT
CH/GID Select A to CH/GID Select D
DTC
Speaker Mute
Mic Mute
External Monitor
External Hook
Emergency
AUX Input Status Message 1 to AUX Input Status Message 3
*1
The function is activated when the Stun state is reset.
O: Enable, x: Disable
FUNC (K)/Ver 4.00
Function
Table 22-2 Activation Conditions for Vibrator on page
See FPRG 8.29.7 without Alert Tone (Vibrator))
Transceiver Status
When the transceiver is
turned ON
x
x
x
O
O
O
O
O
O
O
x
CONTENTS
480.)
While the transceiver is in
the Stun state
x
x
x
*1
*1
O
O
O
O
x
x
INDEX 481