Reserved Statuses Of Status Messages - Kenwood NEXEDGE NX-200 Function Reference

12 FleetSync
12.6 Sending and Receiving a Status Message (Status Call)

Reserved Statuses of Status Messages

There is a reserved status for Status Messages. Below is a list of the reserved statuses.
Status Function
10 to 79 Statuses intended for users
80 Default Status
81 - 86 Undefined
87 Remote Kill Command
88 Emergency Reset Command
89 Horn Alert Activation Command
Remote Stun Transmit Inhibit
90
Command
Remote Stun Transmit/Receive Inhibit
91
Command
92 Remote Stun Reset Command
93 Remote Stun Transmit Inhibit Response -
Remote Stun Transmit/Receive Inhibit
94
Response
Reserved Statuses for Emergency
98: Man-down Status
95 to 99
99: Emergency Status other than
Man-down
*1
Whether status numbers 80 to 99 can be entered for use with Manual Dialing can be enabled or disabled using KPG-111D/ DN. (Refer
to Status 80 - 99 (Special) on page
*2
Horn Alert cannot be used for Portable.
*3
Stun Status will not be changed even if Status is changed in Status Mode.
*4
How the transceiver receives reserved statuses for Emergency (status numbers 95 to 99) can be configured using KPG-111D/ DN.
(Refer to Emergency Status Response on page
Emergency
If the transceiver receives a reserved status message, an Alert Tone sounds from the transceiver based on the Emergency
Status Response configuration.
Remote Stun
If the transceiver receives Remote Stun status (Status 90, Status 91), usage of the transceiver is restricted as follows.
However, the Stun state will be reset upon receipt of the Remote Revive status and the DTMF Stun release command.
Item
Normal Operation Transmit Inhibit
PC Control The transceiver rejects the transmission request.
Whether to accept the received Remote Stun status can be configured using KPG-111D/ DN. (
General 1 Tab > n Stun/Kill Status Validation)
FUNC (K)/Ver 4.00
Table 12-13 Reserved Statuses
Operation on a Receiving transceiver
Reception of a normal Status
The transceiver sends an acknowledge. The
receiving transceiver will be in the Kill state.
This status resets Emergency.
Activates the Horn Alert.
The transceiver sends an acknowledge.
Transmission is restricted. In this case, Current
Status becomes "93".
The transceiver sends an acknowledge.
Transmission and reception are restricted. In
this case, Current Status becomes "94".
The transceiver sends an acknowledge.
Disables the Stun. In this case, Current Status
becomes "80".
-
The transceiver sends an acknowledge. Alert/
*4
Horn/ None
334.)
334.)
Table 12-14 Remote Stun
Transmit Inhibit (Status 90)
Availability of Status Entry
based on the Entry Method
Manual Dialing
Yes
*2
*3
Yes/ No
*3
Transmit/ Receive Inhibit (Status 91)
Transmit/ Receive Inhibit
The transceiver rejects the transmission request.
CONTENTS
PC Control
Yes
*1
FPRG 8.16.2
See
INDEX 331