Kenwood NEXEDGE NX-200 Function Reference page 51

3 BASIC OPERATIONS
3.1 Turning the Transceiver ON/ OFF
2
Enter a password.
Refer to Entering or Deleting a Code on page 48
methods.
A Password Authorization Tone sounds from the transceiver after
the correct password has been entered, and then the password
protection of the transceiver will be disabled.
Power-on Text appears for 2 sec if the Power-on Text is
configured. (Refer to
Either the Channel Name, GID Name, Zone-channel Number or
GID Number appears on the main display. (Refer to
Format on page 79.)
 If the data is not written to the transceiver
1
Turn the Transceiver ON.
"UNPROGRAM" appears on the main display.
Note
• If the firmware is not written to the transceiver correctly, the transceiver will enter Firmware Programming Mode. In this case, write the
firmware to the transceiver again.
• "UNPROGRAM" appears on the main display if no data is written to the transceiver. In this case, data needs to be written to the
transceiver by using KPG-111D/ DN.
FUNC (K)/Ver 4.00
for entry
Power-on Text on page 79.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Display
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
Mobile
Mobile
CONTENTS INDEX 17