Receiving A Status Message - Kenwood NEXEDGE NX-200 Function Reference

12 FleetSync
12.6 Sending and Receiving a Status Message (Status Call)

Receiving a Status Message

A received Status Message is transferred in the following way.
Item
The received Status Message appears on the main display.
If "Fixed" is configured for Message Display Type, only Status Message appears.
Display
The received Status Message appears on the main display for 3 sec and ID Name appears for 2 sec alternately if
"Alternate" is configured for Message Display Type.
Alert Tone Alert Tone sounds if the transceiver receives a Status Message.
The transceiver sends the received Status Message using a serial command. This message is sent to an external
PC command
device that is connected to the transceiver, such as a PC.
Note
• To use serial communications, a user must prepare FleetSync compatible software or external devices.
• A maximum of 15 received Status Messages along with Short Messages can be stored in the stack memory of the transceiver. (Refer
to 3.7 Viewing the Receive History (Stack) on page
• The Status Name appears on the main display when receiving a Status Message. "STATUS xx" appears on the main display if the
transceiver receives a Status Message for which Status Name is not configured. (Refer to
Transceiver Behavior
1
The transceiver starts receiving a Status Message.
"RECEIVE DATA" appears on the transceiver main display.
2
A Status Message is received.
"COMPLETE" appears on the main display.
FUNC (K)/Ver 4.00
Table 12-12 Transferring a Status Message
Description
38.)
Status List on page 333.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS INDEX 328