Analog Modes - Kenwood NEXEDGE NX-200 Function Reference

Outline of This Transceiver

ANALOG MODES

GENERAL
• 12.5 kHz (Narrow)/ 25 kHz (Wide) Channel Spacing
• Conventional & LTR Zones
• FleetSync/ FleetSync II, MDC-1200, DTMF
*9
• QT/ DQT/ 2-tone (Conventional Zones only)
• Single Scan, Multi Scan, List Scan
• Priority Scan
• Voice Inversion Scrambler (16 Codes)
• Analog Scrambler Board Capability
FleetSync
*9
• PTT ID ANI/ Caller ID
*9
• Selective/ Group Call
*3*5
• Status Message
• Emergency, Short & Long Messages
• AUX Input Status Message (Mobile only)
• AUX Output Status Message (Mobile only)
• Ignition On/ Off GPS Reporting (Mobile only)
MDC-1200
*9
• PTT ID ANI/ Caller ID
• Emergency, Radio Check (Decode), Stun (Decode)
*1
Transmission power (High) varies depending on the transmit frequency. (Refer to
*2
Not equipped for NX-200S/ NX-300S.
*3
To send messages or data with serial communications, the supported PC software and external devices need to be separately prepared for the
transmitting transceiver. In addition, to send the received messages or data to external devices, the supported PC software and external
devices need to be separately prepared for the receiving transceiver.
*4
The supported PC software and external devices need to be separately prepared for the transmitting and receiving transceivers.
*5
NX-200S/ NX-300S - Pre-programmed key operation.
*6
The supported PC software and external devices need to be separately prepared for the transmitting transceiver.
*7
A sensor to detect the change of port status needs to be attached to the AUX Input port for the transmitting transceiver.
*8
To remotely control external devices according to the change of port status, the external devises need to be connected to the AUX Output port
for the receiving transceiver.
*9
NX-200S/ NX-300S - LCD dependent and some key-based functions not available.
*10
These trunked features are primarily system programming and operational dependent. Priority Monitor also requires NX subscriber settings.
*11
For KPG-111DN, "Wide" cannot be configured for Channel Spacing if a receive frequency or a transmit frequency is configured in the following
ranges.
VHF: above 149.98750 MHz and less than 174.01250 MHz
UHF: above 420.98750 MHz and less than 470.01250 MHz
FUNC (K)/Ver 4.00
*11
*3
*7
*8
4.2 Transmit Power on page 65.)
CONTENTS INDEX xi