Kenwood NEXEDGE NX-200 Function Reference page 224

9 NXDN TRUNKING SYSTEM
9.1 Initiating Voice Communications (Basic Transmission and Reception)
Receiving
Received audio sounds from the speaker if the transceiver receives a message requesting various types of
communications on a control channel from a system and the received NXDN ID matches the NXDN ID preconfigured for
the transceiver.
Auto Reset Timer
Auto Reset Timer is the amount of time from when the received Unit ID or Group ID matches the Unit ID or Group ID
preconfigured for the transceiver until the LCD, blinking of LED and emission of Alert Tone will automatically be reset.
By using KPG-111D/ DN, Auto Reset Timer can be configured. Also, how the transceiver behaves after the amount of time
configured for Auto Reset Timer elapses can be configured.
Configuration
Off Auto Reset Timer will not be activated.
1 s to 300 s After the configured time elapses, the matching state of the Unit ID or Group ID is automatically reset.
If this function is enabled, the blinking orange Busy LED for the Selective Call Alert LED turns Off when the time
LED
configured for the Auto Reset Timer elapses.
While this function is enabled, the intermittently emitted Alert Tone stops if the amount of time configured for
Alert Tone
Auto Reset Timer elapses.
While this function is enabled, the display will change from one of the following displays to the previous channel
display if the amount of time configured for Auto Reset Timer elapses.
• ID display after receiving an Individual Call or Group Call
• Status Message display after receiving a Status Message
LCD
• Short Message display after receiving a Short Message
Note
This function is unavailable for NX-200S/ NX-300S.
Configuration using KPG-111D/ DN
Configuring the Auto Reset Timer (
Selective Call Alert LED
Selective Call Alert LED is the function to make the LED blink orange when the transceiver receives a call using an NXDN
ID.
A user can notice by the LED that the transceiver is receiving a call.
Note
For NX-200S/ NX-300S, the blinking LED (orange) upon the receipt of a Selective Call indicates the following status of the transceiver.
(a) The transceiver has received a Selective Call (as a status of an incoming call history).
(b) The transceiver can respond to the transmitting transceiver by pressing the PTT switch.
Therefore, if the transceiver receives a Selective Call while the transceiver cannot respond to the transmitting transceiver; for instance,
the transceiver receives an ID inhibited to transmit, the LED blinks orange as the status (a). In this case, the transceiver cannot respond
even if the PTT switch is pressed.
Also, if LED for Auto Reset Timer is disabled and the time configured for Auto Reset Timer has elapsed, the matching status of
Optional Signaling will be reset. At this time, the LED indicating the status (a) continues blinking, so that the transceiver cannot
respond to the transmitting transceiver.
If the LED indicates the status (a), the LED will be turned Off by pressing any key. If the LED indicates the status (b), the LED will be
turned Off by pressing a key to which a specific functions is assigned. (Refer to
FUNC (K)/Ver 4.00
Table 9-1 Auto Reset Timer
FPRG 8.19.3 General 2 Tab)
See
Description
Mode Reset Timer on page
CONTENTS
20.)
INDEX 190