3 BASIC OPERATIONS
3.5 Changing the Zone-channel or GID
Home CH/GID
Home CH/GID can be used to migrate to a preconfigured channel or GID by pressing the Home CH/GID key. The
transceiver can move backward and forward between channels or GIDs in the same zone.
Also, pressing the Home CH/GID Select key can change the Home Channel or GID.
Or, pressing the Menu key causes the transceiver to enter Menu Mode, and then the Home Channel or GID can be
changed by selecting the "Home CH/GID Select". (Refer to
Note
If the Home CH/GID key is pressed during the scan, the transceiver pauses scanning while the transceiver is migrating to the Home
Channel or GID and a Scan Stop Tone will continue to sound at 30-sec intervals. (Refer to
Operating the Transceiver
Migrating to the Home CH/GID
1
Press the
Home CH/GID
Key Beep A sounds from the transceiver, and then the
transceiver can migrate to the Home Channel or GID configured
for the selected zone. "HC" appears on the sub-display.
2
Press the
Home CH/GID
A Key Beep B sounds from the transceiver, and then the
transceiver reverts to the previous channel or GID. "HC" on the
sub-display disappears.
FUNC (K)/Ver 4.00
3.4 Using Menu Mode on page
key.
key again.
23.)
Scan Stop Tone on page
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS
INDEX
458.)
32