Kenwood NEXEDGE NX-200 Function Reference page 178

8 NXDN CONVENTIONAL SYSTEM
8.7 Making a Group Call
Group ID List
The transceiver uses a Group ID configured in the Group ID List to initiate a Group Call in an NXDN Conventional system.
The desired Group IDs must be preconfigured using KPG-111D/ DN for the transceiver to initiate a Group Call. A maximum
of 1000 Group IDs can be configured for Group ID List.
Configuration
A Group ID can be configured in the range between 1 and 65519 inclusive and ALL.
ID
ALL allows initiation of a call to all IDs.
The caller's ID Name is configured. A maximum of 14 characters can be configured for the ID Name.
If the ID Name of the group is configured in the Group ID List, the ID Name appears on the main display
ID Name
when the transceiver receives a call. If the ID Name is not configured in the Group ID List, the Group ID List
number appears on the main display.
The permission or inhibition of transmission of the receiving party can be configured.
The ID for which "Yes" is configured for Transmit Inhibit does not appear on the ID selection display in Group
Call Mode, and a user cannot select the ID in Group Call Mode.
Transmit Inhibit
If the transceiver receives a call from an ID for which "Yes" is configured for Transmit Inhibit, the caller's ID
Name appears on the main display. In this case, a user cannot initiate a call to the party even if the user
attempts to respond by pressing the PTT switch.
The tone type sounding from the transceiver can be configured for a Group Call from the Group IDs
Alert Tone
registered in the Group ID List.
Configuration using KPG-111D/ DN
Configuring the Group ID List (
Display When the Transceiver Receives a Group Call (Group Call Display Type)
Group Call Display Type can be used to display the received information on the main display when the transceiver
receives a Group Call.
Configuration
The Group ID of the received Group Call appears.
If the ID Name is not configured in the Group ID List, the Group ID List number appears on the main display.
Group ID
If the transceiver receives a Status Message with Group Call, the Status Name appears for 3 sec and the
Group ID of the received Group Call appears for 2 sec alternately.
The Unit ID of the transmitting transceiver appears.
The stacked ID Name appears if the ID Name is stored for the Unit ID stacked in the transceiver. If the
received Unit ID is not in the stack memory, the ID Name configured for the Unit ID List appears if the ID
Name of the received Unit ID is configured in the Unit ID List. The Unit ID List number appears if the above
Calling Transceiver ID conditions are not satisfied.
If the transceiver receives a Unit ID Name, the received Unit ID Name will appear after 500 ms elapses upon
appearance of the Unit ID. If the transceiver receives a Status Message with Group Call, the Status Name
appears for 3 sec and the Unit ID of the transmitting transceiver appears for 2 sec alternately.
If the transceiver receives a Group Call from a telephone, "PHONE CALL" appears.
The Group ID of the received Group Call and the Unit ID of the transmitting transceiver appear alternately.
If the transceiver receives a Status Message with Group Call, the Status Name appears for 3 sec, and the
Calling Transceiver ID/ Group ID of the received Group Call and the Unit ID of the transmitting transceiver appear for 2 sec
Group ID alternately.
If the transceiver receives a Group Call, the Group ID of the received Group Call and "PHONE CALL" appear
alternately.
FUNC (K)/Ver 4.00
Table 8-9 Group ID List
FPRG 8.19.7 Group ID List Tab)
See
Table 8-10 Group Call Display Type
Description
Description
CONTENTS INDEX 144