Caller Id Stack; Id/ Message Stack With Time Stamp; Message Memory; Clear Caller Id Stack On Reply (Nxdn System Only) - Kenwood NEXEDGE NX-200 Function Reference

3 BASIC OPERATIONS
3.7 Viewing the Receive History (Stack)

Caller ID Stack

Caller ID Stack allows the transceiver to store the Caller ID of the target party in the stack memory.
The transceiver can store a maximum of 5 Caller IDs.
A user can respond to the displayed Caller ID by pressing the PTT switch while the transceiver is in Caller ID Stack Mode.
When the transceiver receives a call with FleetSync ID or NXDN ID, the "
or NXDN ID is stored. The user can enter Stack Mode to check the stored FleetSync ID or NXDN ID.
The stack method varies depending on the configuration for Latest Received Message Stack.
Configuration using KPG-111D/ DN
Configuring the Caller ID Stack to be enabled or disabled (

ID/ Message Stack with Time Stamp

ID/ Message Stack with Time Stamp allows the transceiver to store a Caller ID, Status Message or Short Message with the
stamp of the received time in the stack memory.
Configuration using KPG-111D/ DN
Configuring the ID/Message Stack with Time Stamp (

Message Memory

Message Memory allows the transceiver to retain the stacked Caller ID, Status Message or Short Message in the stack
memory even after the transceiver is turned OFF.
Configuration using KPG-111D/ DN
Configuring the Message Memory (

Clear Caller ID Stack on Reply (NXDN System Only)

Clear Caller ID Stack on Reply is the function for clearing a Caller ID from the stack memory of the transceiver if the Caller
ID stored in the stack memory is selected and called.
This function is used if a user does not wish to store used Caller IDs in the stack memory of the transceiver.
If this function is enabled, a Caller ID is cleared from the stack memory of a transceiver if the Caller ID stored in the stack
memory is selected and called. The Caller ID will be clear from the stack memory even if a call cannot initiate since the
channel is busy. If the transceiver receives called party transmits a response, the Caller ID will not be stored in the stack
memory while the Mode Reset Timer is counting down.
Also, the Caller ID of the calling party will store in the stock memory, but the Caller ID will clear from the stack memory if a
response is initiated while the Auto Reset Timer is counting down. Subsequently, the Caller ID will not store in the stack
memory even if a call from the same party is received while the Auto Reset Timer is counting down.
Configuration using KPG-111D/ DN
Configuring the Clear Caller ID Stack on Reply to be enabled or disabled (
FUNC (K)/Ver 4.00
See
See FPRG 8.10.6 Common Page 4 Tab)
See FPRG 8.10.6 Common Page 4 Tab)
" icon blinks to notify a user that the FleetSync ID
FPRG 8.10.6 Common Page 4 Tab)
See FPRG 8.19.2 General 1 Tab)
CONTENTS INDEX 41