Kenwood NEXEDGE NX-200 Function Reference page 303

10 ANALOG CONVENTIONAL SYSTEM
10.4 Using 2-tone to Initiate a Selective Call
OST Table
OST Table can be used to configure an encode and decode pair for QT tone or DQT code signaling used for OST. A
maximum of 40 pairs can be configured. The following functions can be configured in the OST Table.
Configuration
A name can be assigned to the OST QT/DQT Encode and QT/DQT Decode pair. A maximum of 14 characters can
OST Name be entered.
"TONE 1" to "TONE 40" appears on the main display if no OST Name is configured.
The QT tone or DQT code to be used to receive a call can be configured. The following QT/DQT Decode range is
available:
QT/DQT Decode
QT: 67.0 Hz to 254.1 Hz (in steps of 0.1 Hz)
DQT: 000N to 777N, 000I to 777I
The QT tone or DQT code to be used to make a call can be configured. The following QT/DQT Encode range is
available:
QT/DQT Encode
QT: 67.0 Hz to 254.1 Hz (in steps of 0.1 Hz)
DQT: 000N to 777N, 000I to 777I
Configuration using KPG-111D/ DN
Configuring the OST Table (
10.4 Using 2-tone to Initiate a Selective Call
2-tone signaling uses a pair of 2 different tone frequencies in series. 2-tone is used for a selective call initiated in an Analog
Conventional system.
A series of two different tone frequencies or single tone is used for 2-tone signaling. Tone frequencies between 288.5 Hz
and 3106.0 Hz inclusive are used.
Following are methods available to send the 2-tone code:
• Selecting from the 2-tone Encode Memory List
• Call key
Note
This function cannot be used in NX-410/ NX-411/ NX-900/ NX-901.
Selecting and Sending the 2-tone Code from a List
By selecting the 2-tone Encode Memory List, the 2-tone code configured in the 2-tone Encode Memory List can be
selected and sent. (Refer to
An Encode Tone configured in Encode Memory List can be selected by pressing the 2-tone key.
An Encode Tone in the 2-tone Encode Memory List also appears by selecting "2-tone" after entering Menu Mode by
pressing these Menu key. (Refer to
Note
This function is unavailable for NX-200S/ NX-300S. For NX-200S/ NX-300S, the 2-tone code can be sent by using the Call 1 to Call 6
keys.
FUNC (K)/Ver 4.00
Table 10-6 OST Table
See FPRG 8.11.1 Conventional Tab)
2-tone Encode Memory List on page
3.4 Using Menu Mode on page
Configuration
272.)
23.)
CONTENTS INDEX 269