Direct Ch/Gid - Kenwood NEXEDGE NX-200 Function Reference

3 BASIC OPERATIONS
3.5 Changing the Zone-channel or GID

Direct CH/GID

Direct CH/GID can be used to migrate to a preconfigured channel or GID by pressing one of the Direct CH/GID 1 to Direct
CH/GID 5 keys. The transceiver can move backwards and forwards between channels or GIDs in each zone.
Pressing one of the Direct CH/GID 1 Select to Direct CH/GID 5 Select keys can change the Direct Channel or GID.
Or, pressing the Menu key causes the transceiver to enter Menu Mode, and then the Direct Channel or GID can be
changed by selecting one of "Direct CH/GID 1 Select" to "Direct CH/GID 5 Select". (Refer to
page 23.)
Note
If one of the Direct CH/GID 1 to Direct CH/GID 5 keys is pressed during the scan, the transceiver pauses scanning while the
transceiver is migrating to the Direct Channel or GID and also Scan Stop Tone will continue to sound at 30-sec intervals. (Refer to
Scan Stop Tone on page 458.)
Operating the Transceiver
 Migrating to the Direct CH/GID
1
Press one of the Direct CH/GID 1 to Direct CH/GID 5 keys.
A Key Beep A sounds from the transceiver, and then the
transceiver can migrate to the Direct Channel or GID regardless
of the selected zone. "DRn" appears on the sub-display. The
selected Direct CH/GID number is entered in "n" on the sub-
display.
If any of the Direct CH/GID 1 to Direct CH/GID 5 keys is pressed
again while Return is enabled, Key Beep B sounds from the
transceiver, and then the transceiver will revert to the previous
channel or GID. "DRn" on the sub-display disappears.
FUNC (K)/Ver 4.00
3.4 Using Menu Mode on
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS INDEX 35