Kenwood NEXEDGE NX-200 Function Reference page 256

9 NXDN TRUNKING SYSTEM
9.7 Making a Group Call (Transmission Trunked)
Receiving a Group Call (Transmission Trunked)
If the received Group ID matches the Group ID configured for the transceiver, the transceiver can receive the Group Call.
Transceiver Behavior
1
The transceiver receives a Group Call.
The Alert Tone (Conference Group Call) sounds from the
transceiver, and then the received Group ID, or the Unit ID of the
transmitting transceiver, or both will appear. (Refer to
When the Transceiver Receives a Group Call (Group Call Display
Type) on page 223.)
The transceiver can respond to the received Group ID by a user
pressing the PTT switch. When a key other than the PTT switch
is pressed, the configured function will be activated. However,
functions that can be used are limited. When an invalid key is
pressed, the Key Beep B sounds, and then the display will restore
to normal state. Refer to
available functions.
Note
• The transceiver can record the receipt of a Group Call. The record can be checked in Stack Mode. (Refer to
History (Stack) on page 38.)
• When the transceiver receives the Group ID for which "ALL" is configured, the transceiver can respond using the Group ID if the
received Group ID is registered in the GID list in the received zone. If no Group ID is configured in the ID List, the receiving transceiver
can receive a call but the receiving transceiver cannot respond to the call. In this case, the ID Name of the transmitting transceiver
does not appear even if Over-the-Air Alias is enabled. (Refer to
• The transceiver can send the ID of the transmitting transceiver from the communication port on the transceiver when receiving a Group
Call.
• An Alert Tone sounds from the transceiver according to the configuration of GID corresponding to the received Group ID.
• If the transceiver receives a Group Call from a telephone, the Encryption function will be disabled.
Configuration using KPG-111D/ DN
• Configuring the Alert Tone (Zone Information) (
System))
• Configuring the Alert Tone (Conference Group Call) which is commonly used (
FUNC (K)/Ver 4.00
Display
Mode Reset Timer on page 20
See
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
for the
Over-the-Air Alias on page 191.)
FPRG 8.1.4 Zone Information Window (NXDN Trunking
Mobile
3.7 Viewing the Receive
See FPRG 8.19.4 Trunking Tab)
CONTENTS INDEX 222