Home Group Revert (Nxdn Trunking System Only) - Kenwood NEXEDGE NX-200 Function Reference

3 BASIC OPERATIONS
3.5 Changing the Zone-channel or GID

Home Group Revert (NXDN Trunking System Only)

Home Group Revert is the function to migrate the transceiver to the Home GID by pressing the key on the transceiver or
automatically in an NXDN Trunking system. (Refer to
Configuration
Manual
Auto
This function is convenient; for example, when a call needs to be initiated by using other Group ID while "Auto" is
configured for this function though the specific Group ID is usually used for transmission, the transceiver can automatically
migrate to the Group ID in normal use without operating the transceiver after the call has been initiated by using the other
Group ID.
Note
In a system in which Group Registration is used, Group Registration will start if 2 sec elapse after a GID has changed. If this function is
configured as "Auto", the transceiver starts counting down the Home Group Revert Timer after the transceiver terminates Group
Registration. At this time, if Home Group Revert Timer is configured as less than 2 sec, the transceiver migrates to the Home GID
before Group Registration starts so that Home Group Revert Timer needs to be configured cautiously.
Configuration using KPG-111D/ DN
• Configuring the Home Group Revert (
• Configuring the Home Group Revert Timer (
FUNC (K)/Ver 4.00
Home CH/GID on page
Table 3-6 Home Group Revert
The transceiver migrates to the Home GID configured in the selected zone
by pressing the Home CH/GID key after a zone in an NXDN Trunking
system is selected. The transceiver migrates to the GID which is selected
before the migration by pressing the Home CH/GID key again.
If the transceiver is turned ON while a zone in an NXDN Trunking system
is selected, the transceiver automatically migrates to the Home GID
configured in the selected zone. The transceiver automatically migrates to
the Home GID configured in the selected zone when a zone in an NXDN
Trunking system is changed to another zone in an NXDN Trunking
system, or a zone in another system is changed to a zone in an NXDN
Trunking system.
Also, if the GID is changed to a GID except the Home GID by pressing a
key on the transceiver after the transceiver migrates to the Home GID, the
transceiver automatically migrates to the Home GID upon the elapse of
the time configured for Home Group Revert Timer.
FPRG 8.19.4 Trunking Tab)
See
FPRG 8.19.4 Trunking Tab)
See
32.)
Description
CONTENTS INDEX 34