Kenwood NEXEDGE NX-200 Function Reference page 325

11 LTR TRUNKING SYSTEM
11.5 Connecting to a Public Switched Telephone Network (PSTN) (Telephone Interconnect)
 Manually calling a Telephone Number
1
Select a GID for which a Telephone ID is configured.
2
Press the PTT switch.
The transceiver receives dial tone after the transceiver connects
to a telephone line, and then the transceiver will be in the phone
off-hook state (dial standby state).
The telephone number can be called by manual keypad operation
using Manual Dialing or Keypad Auto PTT while receiving dial
tone. (Refer to 14.1 Method of Sending the DTMF Code on page
360.)
 Disconnecting from the Telephone Line
1
Press the [#] or Telephone Disconnect
The transceiver terminates the communication.
Note
If Optional Signaling is configured for GID with Telephone ID, Optional Signaling will be disabled.
Configuration using KPG-111D/ DN
Assigning functions to the PF keys on the transceiver (
Automatically Connecting to a Telephone Line (Auto Telephone Search)
Auto Telephone Search can be used to search for and connect to an available RIC repeater to link automatically.
The transceiver automatically searches for an available telephone line to be connected to, and then initiates a call. This
function can be used like the memory dial of a cellular phone, allowing a user to easily and steadily initiate a call.
Zones satisfying all of the following conditions are targets to be searched. If there is no zone satisfying the following
conditions, the Deny Tone sounds from the transceiver and the transceiver does not start the Auto Telephone Search:
• The zone with Auto Telephone Search enabled must exist.
• In the above zone, the repeater configured as the RIC Repeater must exist.
• There must be a GID having an LTR ID configured as an Encode ID that can be connected to a telephone line in
the above zone.
FUNC (K)/Ver 4.00
key during the call.
FPRG 8.12 Key Assignment Window)
See
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS INDEX 291