Kenwood NEXEDGE NX-200 Function Reference page 474

19 SCAN
19.4 Scanning Desired Multiple Zones (List Scan)
19.4 Scanning Desired Multiple Zones (List Scan)
The transceiver scans using List Scan all the channels or GID to be scanned in the zones configured in a Scan List Table.
The transceiver scans all channels or GIDs to be scanned in the zones configured in a Scan List Table.
If the scan starts from a zone in a Conventional Group or LTR Trunking system, the transceiver scans all channels or GIDs
targeted to be scanned in the zones selected from a Scan List Table, except for the zone in an NXDN Trunking system.
If the scan starts from a zone in an NXDN Trunking system, the transceiver scans all channels or GIDs targeted to be
scanned in the zones selected from a Scan List Table, except for the zone in a Conventional Groups or LTR Trunking
system.
If a zone in another zone is selected during the List Scan, the transceiver starts the scan according to the configuration for
Scan Type in the selected zone.
Following are the zone channels (or GIDs) to be scanned:
• The zone configured in a Scan List Table using KPG-111D/ DN
• The channel or GID configured to be scanned using KPG-111D/ DN or the Scan Delete/Add key
• The Priority Channels in all zones except for the zone in an NXDN Trunking system (for a Conventional Group
and LTR Trunking system only)
For using List Scan, "List" must be configured by KPG-111D/ DN for Scan Type in a Conventional Group or an LTR
Trunking system, and "List" must be configured for Scan Type (NXDN Trunking) in an NXDN Trunking system.
Note
• If Selected CH/GID Scan is enabled, the selected channel or GID can be scanned even if the channel or GID is excluded from the
target channels or GIDs for scanning. (Refer to
• In an NXDN Trunking system, a Group ID for which "ALL" is configured or a Group ID configured for Priority Monitor ID is always
scanned regardless of whether the Group ID is configured to be scanned or not.
• In multiple systems in an NXDN Trunking System, only the zone using the same system as the system used in the zone where the
transceiver starts scanning will be scanned.
• If using List Scan, the transceiver pauses scanning when the zone is changed to a zone which is not configured using the Selector for
which "Zone Select" is configured. (NX-200/ NX-200S/ NX-300/ NX-300S only)
• If a zone is changed during the List Scan, the Scan List is changed to the Scan List configured for the zone.
• During a List Scan in an NXDN Trunking system, only the Priority Monitor ID configured for the zone which is selected when the scan
starts is used as a Priority Monitor ID.
FUNC (K)/Ver 4.00
Selected CH/GID Scan on page 457.)
CONTENTS INDEX 440