3 BASIC OPERATIONS
3.8 Operating the Transceiver in Each Mode (Common Operation)
Entering or Deleting Characters
This section explains operations using operating examples for Autodial Programming Mode. (Refer to
List with the Transceiver (Autodial Programming) on page
Refer to
Key Operations for Each Mode on page 531
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Entering characters using the Up and Down keys
Following is the operation example to enter "KENWOOD" in Autodial Programming Mode.
Note
• Following are the main keys to be used for this operation examples.
To select a character: the Up or Down key
To determine: the Menu ([ ]) or [*] key
• Pressing and holding the Up or Down key causes the character to automatically be scrolled up or down continuously.
• Characters to be entered can be changed by configuring the Character Entry. (Refer to
FUNC (K)/Ver 4.00
378.)
for key operations in each mode.
Up or Down key
Select "K".
Menu ([
]) or [*] key (Select)
Up or Down key
Menu ([
]) or [*] key (Select)
Select "E".
Up key
Down key
Up key
Down key
Character Entry on page
CONTENTS
Editing the Autodial
62.)
INDEX
52