Basic Operations; Turning The Transceiver On/ Off; Turning The Transceiver On - Kenwood NEXEDGE NX-200 Function Reference

3

BASIC OPERATIONS

3.1

Turning the Transceiver ON/ OFF

Turning the Transceiver ON

For Portable, rotating the Power switch clockwise causes the transceiver to be turned ON.
For Mobile, pressing the Power switch causes the transceiver to be turned ON. Also, the transceiver can be turned ON by
linking to the status of the Ignition Sense port of a vehicle. (Refer to
with the Ignition Sense Port State (Ignition Sense) on page
NX-200S/ NX-300S
1
Rotate the Power
A Power-on Tone A sounds from the transceiver and the transceiver will be turned ON.
If no data is written to the transceiver when the transceiver is turned ON, the LED lights orange and red alternately and a
Warning Tone A continues to sound from the transceiver.
Note
If the firmware is not written to the transceiver properly, the LED lights orange, and then the transceiver will enter Firmware
Programming Mode. In this case, write the firmware to the transceiver again. (Refer to
Version Information Mode) on page
NX-200/ NX-210/ NX-300/ NX-410/ NX-411/ NX-700/ NX-700H/ NX-800/ NX-800H/ NX-900/ NX-901
 If the data is written to the transceiver and the password is not configured
1
Turn the Transceiver ON.
The Power-on Tone A sounds from the transceiver and all
segments on the LCD light for 500 ms.
If Custom Start-up Screen is configured, the Power-on Tone A
sounds from the transceiver when the transceiver is turned ON
and the bitmapped image configured for the transceiver appears
for 2 sec. (Refer to 5.11 Displaying a Bitmap Image When the
Transceiver is Turned ON (Custom Start-up Screen) on page
FUNC (K)/Ver 4.00
switch clockwise.
508.)
23.1 Turning the Transceiver ON or OFF by Linking
492.)
26.5 Checking the Firmware Version (Firmware
83.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
CONTENTS
Mobile
INDEX 15