Kenwood NEXEDGE NX-200 Function Reference page 249

9 NXDN TRUNKING SYSTEM
9.6 Initiating an Individual Call After Ensuring That the Target Party Is Available for Communications (Message Trunked (Enhanced))
 Stack Mode
A message requesting an Individual Call is sent to a system by selecting an incoming call history in Stack Mode and
then pressing the PTT switch.
Pressing the Stack key places the transceiver in Stack Mode. Or, pressing the Menu key causes the transceiver to
enter Menu Mode, and then selecting "Stack" will cause the transceiver to enter Stack Mode. (Refer to
Mode on page 23.)
 Selcall on PTT
A message requesting an Individual Call is sent to a system by selecting the GID for which the target Unit ID for Selcall
on PTT has been configured and then by pressing the PTT switch. The Unit ID of the target transceiver can be
configured by selecting one Unit ID from the Unit ID List by using KPG-111D/ DN.
 Call key
A message requesting an Individual Call is sent to a system by pressing one of the Call 1 key to Call 6 key. The Unit ID
configured for the key pressed can be called. A Unit ID must be configured to the Call 1 key to the Call 6 key so as to
initiate a call to the specified Unit ID when one of the Call 1 key to the Call 6 key is pressed.
 PC Command
A message requesting an Individual Call is sent to a system by receiving the PC command from the communication
port.
Note
Initiating an Individual Call (Message Trunked (Enhanced)) using Individual Call Mode or Stack Mode is not available for NX-200S/
NX-300S.
Operating the Transceiver
1
Initiate an Individual Call (Message Trunked (Enhanced)) by following one of the methods mentioned
above.
A message requesting an Individual Call is sent to a system.
"<<HOLDING>>" appears on the main display, and the
transceiver waits to receive the response from the receiving
transceiver.
FUNC (K)/Ver 4.00
3.4 Using Menu
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS INDEX 215