19 SCAN
19.8 Common Functions for Scan
19.8
Common Functions for Scan
The following functions are relevant to the scan.
•
Scan Delete/Add
•
Zone Delete/Add
•
Scan List
•
Revert CH/GID
•
Dropout Delay Time
•
Dwell Time
•
Lookback
•
AC Control
•
Priority 1 Temporary Delete/Add
•
Priority 2 Temporary Delete/Add
•
Revert CH/GID Display
•
CH/GID Recall
•
Priority-channel Stop Tone
•
Power-on Scan
•
Selected CH/GID Scan
•
Off-hook Scan
•
Scan Stop Tone
•
Preamble Length
Adding or Deleting a Channel or GID to/from the Target Channels or GIDs for
Scanning (Scan Delete/Add)
Scan Delete/Add is the function to add a channel or GID to the target channels or GIDs for scanning or delete a channel or
GID from the target channels or GIDs for scanning.
With this function, a user can reliably receive a call from a primary channel or GID by deleting unnecessary channels or
GIDs to increase the scan speed.
Following are the transceiver's behavior.
(a) Pressing the Scan Delete/Add key while the transceiver turns Off the scanning adds or deletes a channel or GID to/
from the target channels or GIDs for scanning.
(b) Pressing the Scan Delete/Add key while the transceiver temporarily pauses scanning temporarily adds or deletes a
channel or GID to/from the target channels or GIDs for scanning. This status is retained until the scan is stopped by
pressing the Scan key, and the status will be cleared when the scan is complete.
(c) The Key-error Entry Tone sounds from the transceiver by pressing the Scan Delete/Add key while the transceiver is
scanning and this operation has no effect to the transceiver.
However, for NX-200S/ NX-300S, only the above operation (b) to temporarily delete a channel or GID from the target
channels or GIDs for scanning is available. For NX-200S/ NX-300S, the above operation (a) and the operation to
temporarily add a channel or GID to the target channels or GIDs for scanning is unavailable.
Also, for the transceiver except NX-200S/ NX-300S, the operation identical to the above is enabled even if "Scan Delete/
Add" is selected after the transceiver enters Menu Mode by pressing the Menu key, (Refer to
page
23.)
FUNC (K)/Ver 4.00
3.4 Using Menu Mode on
CONTENTS
INDEX
450